| Title | Injectability of a bone filler system based on hydroxyapatite microspheres and a vehicle with in situ gel-forming ability |
| Publication Type | Journal Article |
| 2008 |
| Authors | Oliveira, SM, Barrias, CC, Almeida, IF, Costa, PC, Pena Ferreira, MR, Bahia, MF, Barbosa, MA |
| Journal | Journal of Biomedical Materials Research - Part B Applied BiomaterialsJ. Biomed. Mater. Res. Part B Appl. Biomater. |
| Volume | 87 |
| Issue | 1 |
| Pagination | 49 - 58 |
| Date Published | 2008/// |
| 15524973 (ISSN) |
| Alginate, alginic acid, Apatite, article, Average diameter, bioengineering, Bone, bone filler system, Bone Substitutes, Calcium, Calcium carbonate, Ceramic, Ceramic microspheres, Coagulation, Colloids, compression, Compression mode, Compression strengths, Compressive Strength, Computerized tomography, Concentration (process), Data compression, Durapatite, Extrusion, Extrusion rates, Fillers, Forming, Gel-forming ability, Gelation, Gels, gluconolactonase, Handling time, Homogeneous distribution, hydrogel, hydroxyapatite, In situ gelation, in situ hybridization, In-situ, Injectability, injection, Injection (oil wells), Micro-CT, microsphere, Microspheres, Mixtures, non invasive procedure, Particle Size, Porous hydroxyapatite, Sodium, Surgery, Surgical procedures, Uniform size, Vehicles, Vertebroplasty |
| The aim of this study was to test the injectability of a bone filler system based on the combination of ceramic microspheres with a gel-like vehicle, for noninvasive surgery. Porous hydroxyapatite microspheres with a uniform size and an average diameter of 535 ± 38 μm were prepared, and their compression strength and friability were tested. The sodium-alginate solution with a concentration of 7.25% (w/v) was used as the vehicle. To promote its in situ gelation, calcium carbonate and D-gluconic-δ-lactone were added to the solution. Microspheres were mixed with the vehicle at different percentages (20-40 wt %). Gelation times in the range of 8-20 min, were obtained, depending on the formulation. Mixtures of HAp microspheres with alginate solution at 7.25% originating a gel in 11 min present an adequate handling time to perform an injection. Their injectability was evaluated using an injection device commonly employed in vertebroplasty surgical procedures, coupled to a texturometer in compression mode. Using an extrusion rate of 0.1 mm/s, the force required to extrude any of the mixtures tested was lower than 100 N. For an extrusion rate of 1 mm/s mixtures with 40 wt % of microspheres were very difficult to inject. Mixtures with 35 wt % of microspheres presented the best compromise between injectability and compression strength of the gelled system. MicroCT analysis revealed a homogeneous distribution of the microspheres inside the vehicle, as well as full interconnection of the intra-microspheres spaces. The compression strength for the gelled systems ranged from 80 kPa (gel itself) to 600 kPa (composite with 40 Wt % of microspheres). © 2008 Wiley Periodicals, Inc. |
| http://www.scopus.com/inward/record.url?eid=2-s2.0-52449123139&partnerID=40&md5=cc648bad01cb2c6aa01d885acac10e8a |
